Stihl HT 100 Instruction Manual page 17

To do this, apply the cutting
N
attachment and pull it across the
bottom of the branch in an arc as far
as the bar nose.
Perform the cross-cut (2) – position
N
the bar with the hook against the
branch and then perform the cross-
cut.
Flush-cutting thick branches
A
4
If branch diameter is more than
4 in (10 cm), first
perform undercut (3) and then
N
cross-cut at a distance of about
8 in./20 cm (A) from the final cut.
Then carry out the flush-cut (4),
starting with a relieving cut and
finishing with a cross-cut.
HT 100, HT 101, HT 130, HT 131
Cutting above obstacles
The unit's long reach makes it possible
3
to prune branches that are overhanging
obstacles, such as rivers or lakes. The
tool angle in this case depends on the
position of the branch.
Cutting from a lift bucket
The unit's long reach enables cutting to
be performed next to the trunk without
the risk of the lift bucket damaging other
branches. The tool angle in this case
depends on the position of the branch.
30° angle drive (special accessory)
1
2
The angle drive keeps the cutting
attachment at an angle of 30° to the
drive tube.
The angle drive may be adjusted on the
drive tube to the following positions only:
1 For cross-cutting vertical branches
and bushes.
2 For a better view of the cutting
attachment.
English
15