Programming (Flowcharts) - Laundrylux DAWS0 SERIES Operating Manual

Hide thumbs Also See for DAWS0 SERIES:

Installation manual (22 pages)

Table Of Contents

Table of Contents

The "HI TEMP" or "LO TEMP" key provide the following

functions:

Change numeric values..."HI TEMP" increases and "LO TEMP"

decreases.

Flip-flop for status changes...by pressing either key, a status

will revert back and forth no matter which of the two keys is

pressed.

If the change to be made is a numerical one (i.e., time or

temperature), the operator must now press the "HI

key to increase the number value, or press the "LO

key to lower/increase the number value. Pressing the "PERM

PRESS" key will store the change and advance to the next

step (bit) or program location.

NOTE: To accelerate increase/upward value, press and

hold in "HI TEMP" key. To accelerate decrease/downward

value, press and hold in "LO TEMP" key.

When making numerical changes, please keep in mind to

stay within the programming limits shown.

If the change to be made is a st atus change (i.e., to change

from °FAr to °CEL) simply press the "HI TEMP" or "LO TEMP"

key and the L.E.D. display will revert back and forth between

status choices (i.e. "Grd" and "nGrd"). Once the correct st atus

is displayed, pressing the "PERM PRESS" key will store the

change and advance to the next step (bit) or program location.

Once the change or changes desired are made, to exit program

mode flip up (open) the PS.

NOTE: You can exit the programming mode at any time

(even if you are in the middle of a program location) by

simply opening the PS. However, if a change was made

be sure the "PERM PRESS" key is pressed before opening

the PS to ensure the change was stored in the

microprocessor controller's (computer's) memory.

Programming (Flowcharts)

This section explains the programming through the use of

flowcharts. A flowchart is nothing more than a diagram of the

programming process.

Represents the microprocessor L.E.D. display. For example,

if the flowchart shows the symbol "FILL," the computer L.E.D.

display will read the same.

Represents the key on the label that is to be pressed. For

example, if flowchart shows "HI TEMP," you would press that

key on the label.

Represents the program path.

On the side of each flowchart is an explanation of the chart

procedures, in some cases, the programming limit s.

112999 - 1

Notes _______________________________________________________

____________________________________________________________

TEMP"

____________________________________________________________

www.Laundrylux.com

Table of Contents

Show Quick Links

Hide quick links:

Table of Contents

This manual is also suitable for:

Dawf0 series

Programming (Flowcharts) - Laundrylux DAWS0 SERIES Operating Manual

Programming (Flowcharts)

Hide quick links:

Related Manuals for Laundrylux DAWS0 SERIES

Related Products for Laundrylux DAWS0 SERIES

This manual is also suitable for:

Table of Contents