Zero Configuration Setup - D-Link DCS-5222L Quick Install Manual

Zero Configuration Setup

The Zero Configuration Setup will only work with a registered
Cloud Router and an active mydlink account. Your Cloud Router will
automatically assign your network settings (both wired and wireless)
to your camera, and add it to your mydlink account.
If you do not have a D-Link Cloud Router, skip to the Easy Setup section.
Attach the power supply to the
1
power receptor located on the back
of the DCS-5222L and connect it to
a wall outlet or power strip. Power is
confirmed when the Power LED is lit.
If using an Ethernet connection:
2
Connect the included Ethernet cable
to the Ethernet port located on the
back of the DCS-5222L and connect it
to your router.
If using a wireless connection: Press
and hold the WPS button on the side
of the camera for five seconds. The
blue WPS status LED will start to blink.
Then, press the WPS button on your
Cloud Router within two minutes.
From any computer, open a web
3
browser, go to http://www.mydlink.
com and log into your account. Once
mydlink detects your camera, a notice
will appear that there is a new device
detected. Click on your camera from
the New Devices list and then click
Yes to add your camera.
Your setup is complete!
4