Change Factory-Presets; Split Mode - UHL Instruments X3-1 Owner's Manual

Change Factory-Presets

All 14 factory presets can be replaced by your own favorite presets.
In the following example we change factory preset no. 6 for the lower manual.
2. Select with
Data/Entry Knopf
Factory-Preset No. 6
Press the Down button as many times until the display indicates the 9 drawbars of the lower manual. Adjust the
drawbars either with the Data Entry knob or with the physical drawbars. Then press the Data Entry knob for
two seconds to store the preset. Now you created your own lower manual preset no. 6.
Change value with Data
/ Entry button or with
real drawbars 16 "of the
lower Manuals
The factory presets of the upper manual are changed equally: move the cursor to the upper manual  select
the preset number with the Data Entry knob  then press the Up button as many times as required to get to
the drawbar settings  change drawbar values as described above  press the Data Entry knob to store your
settings.

Split Mode

There are 3 options in split mode (see page 12):PedalToLower
LowerToUpper
PedalToUpper
1. Set with up/down
button cursor on Lower
Manual
C o p y r i g h t b y U h l - I n s t r u m e n t s
Store Value with Data / Entry
button (pressed 2sec hold)
Asterisk then disappears
M a n u a l Page 22