Menu/Display; Save Mode - UHL Instruments X3-1 Owner's Manual

Menu/Display

Menu Panel Display Controls
The menu panel display offers full access to many X3 parameters like percussion,
cabinet, reverb, factory presets, leakage, tapering. All parameters can be stored individually.
Use Up/Down buttons to scroll through menu items.
Use the Data Entry incremental encoder knob to change parameter values by turning the knob either right or
left. A changed parameter is indicated by an asterisk in the display. To store changed settings press the Data
Entry rotary knob for 2 seconds until the [Saved] message appears. Hereafter the asterisk disappears.
.
If you change more than one parameter, every single parameter change must be stored individually.
To find parameters which have not been stored, just use the Up/Down buttons to scroll through the
complete menu and look out for asterisks. Then press the Data Entry knob for 2 seconds to permanently
store each parameter still showing an asterisk.

Save Mode

Press the Data Entry knob for 2 seconds to permanently store parameter changes. The asterisk disappears after
saving.
Display Data/Entry Button
(Rotary-Switch + Button)
The organ was transposed
by a semitone – die Change
is active but not stored for
future: Asterisk appears
C o p y r i g h t b y U h l - I n s t r u m e n t s
Menu Up -Button
Menu Down -Button
chorus/vibrato, keyclick, rotary-
The change has been saved for
the future: the asterisk is no
longer displayed.
M a n u a l Page 20