Audio Output Configuration A/B; Tone-Control - UHL Instruments X3-1 Owner's Manual

Audio Output Configuration A/B

A/B Button
HX3 generates selectable output signals: stereo rotary simulation = L/R, plain organ = ORG, bass pedal = PD and
organ with tube amp simulation = AMP.
The X3 output signals can be routed to any of the 4 jack s of the two output pairs MAIN OUT and AUX OUT. Two
configurations are available, so you may set these for your own needs and toggle between them with the OUT B
button on the panel board.
• AudioJ Conf A sets audio jack configuration A
• AudioJ Conf B sets audio jack configuration B
The audio output routing is fully programmable with the Menu/Display panel (see page 20).

Tone-Control

Tone-Regler
Cranked up high frequencies accentuate the key click and percussion. Turn the knob counter-clockwise to
reduce high frequencies.
It is recommended to discreetly dial back the high frequencies if the X3 is played with
very high volume levels during live performance.
C o p y r i g h t b y U h l - I n s t r u m e n t s M a n u a l Page 16