Sub-Zero BI-36R Installation Manual page 31

Panel Installation
Flush Inset Panels
Install the handle hardware before inserting the panel.
Sub-Zero recommends using larger D-style pulls. The use
of small, one-piece knobs is not recommended. If you use
screws with thick heads, you will need to countersink the
screws into the backer panel before sliding the assembly
into place.
Slide the panel into the frame on the door. With the panel
in position, replace the frame end. Make sure the panel is
inserted completely into the channel for proper fit and
alignment.
To reinstall the trim molding on side-by-side models and
the upper door for over-and-under models, insert the top
of the trim molding into the grooves at the top of the door
and work downward, snapping the trim molding into the
clips on the frame.
For the drawer on over-and-under models, start at one
end and move towards the opposite end, snapping the
trim molding into the clips on the frame.
GRILLE PANEL ASSEMBLY
Remove the grille panel assembly as described on page
16. Remove the top two corner screws and pull away the
top frame. Slide the panel into position in the grille frame.
If you are using a grille panel
need to install a filler.
Reattach the top frame by reinstalling the two top corner
screws. Install the inner grille panel assembly onto the
unit, by reversing the grille removal procedure outlined on
page 16.
Refer to specifications for flush inset grille panels on
pages 32–33 and the illustrations on the previous page for
the exact sizing of all three panels.
Do not exceed the panel dimensions listed for the
appropriate flush inset grille panel you are specifying.
The flush inset decorative panel cannot be any larger
or it may restrict the air flow to the compressor area
and cause problems with the operation of the Sub-Zero
unit.
subzero.com/specs
1
/ " or thinner, you will
(6)
4
31