Sub-Zero BI-36R Installation Manual page 17

Built-In Installation
Position the Unit
Before moving the built-in unit into position, secure
door(s) closed and protect any finished flooring.
Use an appliance dolly to move the unit near the rough
opening. Each built-in unit is equipped with rollers, so it
can be moved into position more easily. If possible, keep
the door(s) closed until the unit is properly anchored.
The rear levelers must be in their lowest position in order
to roll the unit back into the rough opening. Leveling
cannot be completed until the unit is in position.
Shut off power to the electrical outlet. Plug the power cord
into the grounded outlet and roll the unit into position.
Make sure the anti-tip brackets are properly engaged.
IMPORTANT NOTE: If for any reason the unit has been
laid on its back or side, you must allow the unit to stand
upright for a minimum of 24 hours before connecting
power.
IMPORTANT NOTE: If used, side panels will need to be
installed before the unit is placed in its final position. Refer
to page 35.
Water Line Connection
Approximately 3' of
(.9 m)
to the unit with a preassembled
tion at the end. This tubing is located under the unit.
The water line fitting connection kit, provided with the unit,
1
contains a / " compression union fitting for connection to
4
the household water line. Place the sleeve and nut on the
water line and fasten to the connection at the end of the
tubing under the unit. Do not over tighten. Check all water
line fittings for leaks. Make sure the drain pan can be
removed without water line interference.
Purge the water line prior to final connection to the unit.
This will remove any debris that may be present in the
tubing from installing the new water line.
IMPORTANT NOTE: If a reverse osmosis system used,
it is recommended that the water filtration system be
bypassed. Refer to water filter bypass mode on page 21.
IMPORTANT NOTE: Let your customer know that the ice
maker will not produce ice immediately, and that the first
few batches of ice produced should be discarded. Allow
24 hours for proper ice production.
IMPORTANT NOTE: Water lines must not be exposed to
freezing temperatures. Exposure could cause damage to
the unit and home.
subzero.com/specs
1
/ " plastic tubing is connected
4
1
/ " compression connec-
4
17