Sub-Zero BI-36R Installation Manual page 19

Built-In Installation
Door Adjustment
DOOR HEIGHT ADJUSTMENT
To adjust a left-hinge door; using a
the bolt clockwise to raise the door and counterclockwise
to lower the door. Refer to the illustration below. Reverse
the directions for a right-hinge door.
Door height adjustment.
1
/ " allen wrench, turn
4
Panel Installation
If your customer has ordered either a framed or overlay
model, you will be installing door panel(s) to give the unit
the custom Sub-Zero look. Before you begin installing
panels, refer to the panel specifications for framed,
overlay or flush inset applications on pages 22–34, and
make sure you are working with the panel design called
for in your installation.
IMPORTANT NOTE: For overlay models, there are two
design applications, overlay and flush inset. Be sure to
use the correct panel sizes for your application.
If your customer has chosen the stainless steel design, the
unit has been shipped complete with a finished stainless
steel look. It will not be necessary to install door panels or
handle hardware. In your final preparation for stainless
steel units, use a stainless steel cleaner to remove any
marks. Abrasive cleaners should not be used, as they may
scratch the surface.
19
subzero.com/specs