Update Cautions; Caution 1; Caution 2; Caution 3 - Ricoh SG 2100N User Manual

3. Update Cautions

This section describes several things you must check for to ensure successful up-
dates.
You must read this section before performing updates.
* For more details about cautions, refer to "ReadMe.txt".

Caution 1.

To update the firmware to version 2.0.0 or later, the current firmware must be version
1.9.0.
If the current firmware is earlier than version 1.9.0, update it first to version 1.9.0, and
then to version 2.0.0 or later.
To check the firmware version, print the configuration page.
[ /Menu] [List/Test Print] [Config. Page]

Caution 2.

Before performing updates, check your computer's power options: make sure [Put the
computer to sleep] is set to "Never".
To check your computer's Power Options under Windows 7 (procedures for other op-
erating systems will differ):
1. Click the [Start] menu.
2. Click [Control Panel].
3. Click [Hardware and Sound].
4. Click [Change when the computer sleeps].
5. Make sure [Put the computer to sleep] is set to "Never".

Caution 3.

During updates, make sure the machine's power is not turned off and the network or
USB cable remains connected. Also, during updates, do not print any jobs or run ap-
plications that use the printer driver, Status Monitor, or SmartDeviceMonitor.

Caution 4.

If the machine's power is turned off or the USB or network cable is disconnected during
updates, the update will fail and must be performed again.

Caution 5.

During updates, do not put the computer into [Put the computer to sleep] manually.
3