Table of Contents
Advertisement
Connection
Before starting the connection, turn off the power of the devices to be connected.
Check and prepare the required devices and cables for connection.
a
Connect a LAN cable (category 5 or better, straight, STP) between a PoE device (such as a
hub) and the network connector of the camera.
IMPORTANT:
• Use all 4 pairs (8 pins) of the LAN cable.
• The maximum cable length is 100 m {328 feet}.
• Make sure that the PoE device in use is compliant with IEEE802.3af standard.
• When the LAN cable is disconnected once, reconnect the cable after about 2 seconds. When
the cable is quickly reconnected, the power may not be supplied from the PoE device.
• The network camera is only intended for a connection to a PoE network without routing to the
outside plant.
Network cable
RJ-45 (female)
25
Advertisement
Table of Contents
