Table of Contents
Advertisement
Installation
The position of mounting screw in mount bracket
Mounting screw hole A: For standard mounting position on the wall
Mounting screw hole B: For installing with a two-gang junction box
Mounting screw hole C: For installing with a one-gang junction box
Install the camera directly on the wall
Note:
When installing the camera outdoors, caulking is necessary if the environment does not meet the
following conditions.
• Install camera with a mount bracket through mounting screw hole A.
• After installing mount bracket, make sure that there is no interspace between installation sur-
face and mount bracket.
• Make sure the installation surface is flat without unevenness. (When installed on wooden walls,
sandy walls, brick walls, cement walls and other surfaces, please implement waterproof treat-
ment in advance if the surfaces are uneven.)
• Make sure that the surfaces are not attached with dirty, dust, sand, etc.
However, it is necessary to implement the waterproof treatment for the cable joint sections.
(
Page 26)
☞
a
Mount the mount bracket with 4 screws (M4) through mounting screw hole A.
b
Drill a cable access hole with a drill.
c
Install the camera and tighten the camera tamperproof screw.
(Recommended tightening torque: 0.58 N·m {0.43 lbf·ft})
d
Adjust the camera angle. (
e
Adjust the focus of the lens. (
f
Install the dome cover and dome cover ring.
Page 22)
☞
Page 23)
☞
19
Advertisement
Table of Contents
