Table of Contents
Advertisement
Appendix A: Troubleshooting
This appendix provides solutions to problems that may occur during the installation and operation of the Phone
Adapter. Read the description below to solve your problems. If you can't find an answer here, check the Linksys
website at www.linksys.com.
Common Problems and Solutions
1. I don't hear a dial tone, and the PHONE1 (or PHONE2) LED is not lit.
Go through this checklist until your problem is solved:
•
Make sure the telephone is plugged into the appropriate port, PHONE 1 or PHONE 2. (You should use the
Phone 2 port only if you have more than one phone line.)
•
Make sure the ETHERNET LED on the front panel of the Phone Adapter is lit. If it is not lit, then check your
router and network connection to the Internet.
•
Pick up the telephone. Press 80#. Hang up the telephone. Wait approximately 30 seconds. Then pick up
the telephone; you should now have a dial tone.
•
Follow these instructions to reboot your cable or DSL modem, Phone Adapter, and router:
1. Power off your cable or DSL modem by unplugging its power adapter.
2. Power off the router by unplugging its power adapter.
3. Power off the Phone Adapter by unplugging its power adapter.
4. Wait two minutes, and then power on your cable or DSL modem by plugging its power adapter into
an electrical outlet.
5. Wait two minutes, and then power on the router by plugging its power adapter into an electrical
outlet.
6. Wait five minutes, and then power on the Phone Adapter by plugging its power adapter into an
electrical outlet.
Appendix A: Troubleshooting
Common Problems and Solutions
Phone Adapter with 2 Ports for Voice-over-IP
15
Advertisement
Table of Contents
