Advertisement
Quick Links
Linksys Sipura and PAP2 Analog Telephone
Adapter (ATA) - Installation Instructions
Below you will find installation instructions for the Linksys Sipura-200X or PAP2 broadband phone
adapter.
Setting up your Linksys ATA to work with KONTACT+ phone network is easy! The following
instructions will help you set up your adaptor in a simple Step-by-Step method.
Introduction:
How does broadband phone work?
Step 1:
Connect ATA to your Broadband connection
Step 2:
Verify & Configure your IP address
Step 3:
Prepare you device to work with phone network
Step 4:
Complete the Setup-Wizard
Step 5:
Start using your ATA with KONTACT+ phone network
Introduction: How should the broadband adaptor connect to your
network?
You must have a broadband Internet connection and the Linksys ATA. Since the adaptor works
independently of your computer, there are no requirements at all for your operating systems.
In some case you will not necessarily need a router if your cable modem has 2 Ethernet ports and supports
NAT.
Routers and Broadband service are not sold through KONTACT+ phone network. Routers are generally
available from most retail or online stores.
Please follow the following step-by-step guide below to setup your Linksys ATA to work with
KONTACT+ phone network Broadband Phone Service.
Advertisement
Related Manuals for Linksys Sipura
Summary of Contents for Linksys Sipura
- Page 1 Linksys Sipura and PAP2 Analog Telephone Adapter (ATA) - Installation Instructions Below you will find installation instructions for the Linksys Sipura-200X or PAP2 broadband phone adapter. Setting up your Linksys ATA to work with KONTACT+ phone network is easy! The following instructions will help you set up your adaptor in a simple Step-by-Step method.
- Page 2 If your network utilizes a DHCP Server to assign IP Addresses to network devices, or if you are connecting the ATA to a home router such as a Linksys or Netgear router, please do the following: 1. Pick up the phone connected to Phone 1 of the ATA and enter "* * * *". You will hear a voice prompt saying "Linksys configuration menu.".
-
Page 3: Appendix 1. Ivr Menu
For instruction how to manually configure your static IP click here. back to top Step 3: Prepare you device to work with phone network If you have purchased your Linksys ATA adaptor from KONTACT+ phone network you should skip this step and proceed to Step 4. - Page 4 Enter IVR Menu * * * * None None. Ignore SIT or other tones until you hear, “Linksys configuration menu. Please enter option followed by the pound key or hang-up to exit.” Check DHCP 100# None IVR will announce if DHCP in enabled or disabled.
-
Page 5: Appendix 2. Router Configuration
Appendix 2. Router configuration. To connect your ATA to our service your router must have opened UDP ports. In case you use "Port forwarding" mode to your ATA LAN IP, you must forward UDP ports: 5060,5061,5062,7060 - Sip signalling 16384-16482 - Media Ports In case you use "NAT"...