Steps to configure Linksys - PAP2 Analog Telephone Adaptor Configuration Guide...
Page 2
Overview This guide shows how to configure Linksys PAP2 Analog Telephone Adaptor (ATA) so you can use the Owtalk service. But first you must be an Owtalk subscriber. Linksys ATA can be available in preconfigured mode, labeled as Owtalk Preconfigured on the surface of the packaging box. Under the preconfigured mode, all Owtalk SIP account information are pre-programmed, you don’t...
Page 3
Owtalk after sign-up or click View SIP Account Configuration Fill in the 10-digits Owtalk SIP User Name in the field of Display Name, User ID and Auth ID. Fill in the Owtalk SIP Password in the field of Password.
Page 4
The SIP port number is set at 6060. For the remaining tabs, you can accept the default settings, or you change them to suit your setup. Click Save Settings to enable the settings. After the ATA set up procedure is complete, the device is ready for use and you can now receive and make outgoing calls.
Page 5
Appendix A Owtalk Preconfigured Linksys ATA To activate your Owtalk preconfigured device, you need to obtain an My Account activation number. Go to after sign-up for Owtalk at http://www.owtalk.com. Press Port to Preconfigured and click Next to get the activation number.