Linksys PAP2 Configuration Manual
Hide thumbs
Also See for PAP2:
- Installation and troubleshooting manual (75 pages) ,
- User manual (17 pages) ,
- Installation manual (10 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Linksys PAP2
Summary of Contents for Linksys PAP2
-
Page 1: Configuration Guide
Configuration Guide for the Linksys PAP2... -
Page 2: Set Up Your Pap2
2. Using a standard network cable (RJ-45), connect the LAN port on the PAP2 to your network connection (e.g., LAN). 3. Power on the PAP2 by plugging its power supply into an AC outlet and then plugging the power cable into the Power port on the PAP2. -
Page 3: Configure Your Pap2 For Outbound Calling
PAP2’s IP address, write it down. To configure the PAP2 to make outbound calls: 1. Using a PC on the same network as the PAP2, launch a Web browser, and in the Address bar, enter the PAP2’s IP address (obtained in the previous section). - Page 4 Landose Configuration Guide for the Linksys PAP2 Line 1 Configuration Page – Top 10. In the Audio Configuration section, change the value of the following fields: Preferred Codec— G723 Use Pref Codec Only—no G729a Enable—no G723 Enable—yes G726-16 Enable—no Page 3...
- Page 5 12. To save these settings, click the Submit All Changes button. 13. On the Line 1 and Line 2 configuration pages of the Linksys PAP2, please change the following settings in the Supplementary Service Subscription section from "Yes" to "No":...
Need help?
Do you have a question about the PAP2 and is the answer not in the manual?
Questions and answers