Drain Hose - Thermador DW244UB Installation Instructions Manual

Mounting brackets
Hot water line
Figure 10.
It is recommended that the cardboard or styrofoam
shipping base be kept under the dishwasher until it is
installed. The cardboard/styrofoam will help to protect
the floor during installation.
Figure 11.
The rear leveling leg is adjusted by turning the center
screw at the front of the dishwasher. The front leveling
legs are adjusted by rotating the front leveling legs. See
Figure 11, above.
If additional height is needed, shims may be added under
the leveler feet.

Drain hose

Electric supply cable
Drain Hose
If the 7 foot drain hose provided is not long enough, an
additional piece of hose is needed to connect the drain
hose to the sink, disposer or air gap. The rubber drain
hose must be resistant to heat and detergent. The drain
hose may be obtained from a plumbing, hardware or
automotive supply outlet.
Figure 12.
DO NOT use a drain hose or fittings less than 5/8" I.D.
Air gap
Rubber connector
Entry must be
above trap
Figure 13.
5
See Fig. 2
T