Introduction; Tools Needed For Installation; Materials You Will Need; Accessory Parts Supplied - Thermador DW244UB Installation Instructions Manual

Introduction

Please read these installation instructions completely
and carefully. They will save you time and effort and help
to ensure optimum dishwasher performance. Be sure
to observe all listed warnings and cautions.
These installation instructions are intended for use by
qualified installers. In addition to these instructions the
dishwasher shall be installed:
• In the United States, in accordance with the National
Electric Code/State and Municipal codes and/or local
codes.
• In Canada, in accordance with the Canadian Electric
Code C22.1 - latest edition/Provincial and Municipal
codes and/or local codes.
These shall be carefully followed at all times.
If the dishwasher is a new installation most of the work
must be done before the dishwasher is moved into place.
If the dishwasher is replacing another dishwasher the
connections for the dishwasher being replaced must be
checked for compatibility with the new dishwasher and
replaced as necessary.

Tools Needed for Installation

A. Tape Measure
B. Flat blade screwdriver
C. Phillips screwdriver
D. Torx screwdriver, #20
E. Electric Drill
F. Hole saw or 1" hole cutter
G. Hammer
H. Level
I. Open end wrench
J. Adjustable wrench, 2 required
K. Pipe wrench, 2 reqd.
L. Wire Cutter
M. Wire stripper

Materials You Will Need

• Minimum 3/8" O.D. copper tubing of sufficient
length for your installation.
• Shut-off valve and fittings for hot water supply
line.
• 90° elbow with 3/8" N.P.T. external threads on
one end and sized to fit your water supply line on
the other end.
• Teflon tape or other pipe sealant.
• 3 twist-on wire connectors for 16 AWG wire.
• UL listed conduit connector or strain relief.
Additional materials may be required to comply with
local codes.
Tools Needed For Installation
A
B
C
D
E
F
G
Figure 1.

Accessory Parts Supplied

Check to make sure that the accessory parts supplied
for your model, see Figure 1, are all there. If any parts
are missing contact your dealer immediately.
Refer to Figure 2
O. Cover Plugs (2)
P. Screws (2), for terminal box cover/toe panel
R. Mounting brackets (2)
S. Sheet metal screws (2)
T. Drain hose clamps (1)
U. Screws, M6 x 26 (2)
V. Mounting brackets (4) and screws (8)
W. Template sheet with instruction pictograms.
Accessory Parts Supplied
Models DW244, DW245
DW246
R
P
S
T
Figure 2.
1
H
I
I
J
K
L
M
Model DWI246
O
R
V
U
P
S
T
W