System Test - Honeywell evohome Installation Manual

Step 4: System test
Now that all the devices are bound to your evohome
Controller and installed in their final locations, check that
the system works properly and that all the devices are
responding to commands from the evohome Controller.
You can perform a simple functional check of the heating
system by overriding the temperature of each zone to their
minimum and maximum while listening for a response from
the radiator (or zone) controllers and boiler. To save power
the battery devices only communicate with the evohome
Controller every four minutes therefore the system may not
respond immediately to a manual temperature change.
In this section
Advanced RF communication check
Mains Powered Wireless Devices
Battery Powered Wireless Devices
evohome Installation Guide 29
30
30
31