Powering Up Your Evohome Controller - Honeywell evohome Installation Manual

10

Powering up your evohome Controller

!
Your evohome
Controller comes
with *rechargeable
batteries which are
pre-charged allowing
you to set-up the system
while off the table
stand or wall bracket.
Place the evohome
Controller on the table
stand or wall bracket
for normal use.
*Only use the
AA rechargeable
batteries provided
Step 2: Set up your Central Controller
First, power up the evohome Controller
Remove the cover, remove the battery
1
tab and replace the cover
Place it on the table stand or wall bracket
2
Once the batteries are fully charged, the evohome
3
Controller can be easily removed from the table stand or
wall bracket for ease of programming. After 30 minutes
the evohome Controller will emit a beep to indicate that
it should be replaced on the stand or wall bracket
1
PULL TAB