Radiator Controllers (Hr92); Bind The Radiator Controllers (Hr92) - Honeywell evohome Installation Manual

14

Radiator Controllers (HR92)

evohome
Controller
If you are NOT
following GUIDED
CONFIGURATION
follow these steps
on your evohome
Controller display first:
1. Press and hold
'Settings' for 3
seconds
2. Press the green tick
3. Press ADD ZONE
4. Press the zone you
want to add the
Radiator Controller to
5. Rename the zone if
required and/or press
the green tick
6. Press RADIATOR
VALVE
7. If you want to control
the zone temperature
with the evohome
Controller (which
needs to be located in
that zone) press YES,
otherwise press NO.
You must repeat these
steps for each radiator
controller.
1 2
Step 3: Power up and bind devices
Power up and bind Radiator Controllers
(HR92) – Your evo Zone Kit

Bind the Radiator Controllers (HR92)

Remove the circular top cover
1
Open the battery clip and insert the AA batteries supplied
2
Close the clip and replace the cover
3
Press the button once − it should say UNBOUND
4
Press and hold the
5
5 seconds until it says BIND
Press the button once – it should say BINDING
6
You should receive a SUCCESS message on the
7
evohome Controller (if not go back and re-bind)
The name of the allocated zone should appear on
8
the HR92 display when you press the
Either press the green tick
9
radiator to the zone. Or press the red cross
you don't need to add another radiator to the zone
4 5
PRESS
ONCE
button for a further
to add another
6
PRESS PRESS
5 SEC ONCE
button
if