Ssd/Hdd And Fan; Removing The Ssd/Hdd And Fan - Toshiba NB100 Maintenance Manual

4 Replacement Procedures

4.6 SSD/HDD and Fan

Removing the SSD/HDD and Fan

CAUTION: Do not press on the top or bottom of the drive.
Applying such pressure can either corrupt the data in the drive or
damage the drive.
Remove the SSD/HDD (hard disk drive) and Fan according to the following procedures and
Figures 4-12, 4-13 , 4-14.
1. Remove the two M2.5 x 4 flat-head screws on the SSD/HDD pack.
2. Remove the SSD/HDD pack by pulling on the tab attached to the pack.
3. Remove one M2.5 x 7 black flat-head screw on the Fan.
4. Disconnect the Fan cable form CN9.
5. Remove Fan.
M2.5 x 4 black flat-head screw
NOTE: Do not disassemble the HDD pack when it is working normally.
Disassemble or replace the HDD pack only if it fails.
4-24
Figure 4-12 Removing the HDD pack
4.6 SSD/HDD and Fan
M2.5 X 7 black flat-head screw
TOSHIBA NB100 Maintenance Manual
CN9