LED Indicators
Below is a table that explains the status of each the power and network status LED's
found on the front panel of the EIR405-SFP-T.
LED
Color
P1
Green
P2
Green
Fault
Red
LNK/ACT (SFP)
Green
Ports 1 to 4
Green
(Upper LED)
Ports 1 to 4
Green
(Lower LED)
Ports
RJ-45 ports: The RJ-45 ports auto-sense for 10, 100 or 1000 Mbps devices connections.
The auto MDI/MDIX feature allows connections to switches, workstation and other
equipment without changing straight through or crossover cabling. The charts below
show the cable pin assignments for straight through and crossover cables.
RJ-45 Pin Assignments
Note
"+" and "-" signs represent the polarity of each wire pair.
6
Description
On
Power input 1 is active
Off
Power input 1 is inactive
On
Power input 2 is active
Off
Power input 2 is inactive
On
Power input 1 or 2 is inactive
Power input 1 and 2 are both functional, or no power is
Off
applied
On
Connected to network
Flashing
Networking is active
Off
Not connected to network
On
Connected to network
Flashing
Networking is active
Off
Not connected to network
On
Connected to network at speeds of 1000Mbps
Off
Not connected to network
Pin Number
1
2
3
6
Assignment
Tx+
Tx-
Rx+
Rx-
Manual Document Number EIR-SFP-T-0109m
Hardware Installation
www.bb-elec.com
www.bb-europe.com