Table of Contents
Advertisement
Video Output
Connect the monitors to VGA and CVBS out connector. Dual Display allows user to use both VGA
and CVBS outputs same time with different display options. Two different and individual display
modes can be set on each monitor output. Also Live Monitoring on one monitor and Playback on
another Monitor can be displayed and controlled at the same time. This function will provide such
high flexibility and efficiency for monitoring options for users.
Note
: VGA Monitor is set as a main monitor when system boots up. To move to another monitor
(CVBS) and control it, please use one of following control options.
1. Press and Hold Display button for 3 seconds.
2. Click 2 mouse buttons at the same time.
3. Choose "Move Display Focus" on the contextual menu on GUI.
RS485/ALARM/SENSOR
3 sensor input and 1 emergency sensor input connectors are provided to connect external
devices. You can use sensors to signal the DVR with event. The emergency sensor is designed for
Emergency recording only. It will follow Emergency recording setting when it is triggered.
An RS-232C connector is provided to connect an ATM or POS machine for Text-In function.
To make connections on the terminal block, press and hold the button and insert the wire in the
hole below the button.
ETC
• Network: Connect a Cat5 cable with an RJ-45 connector to the DVR connector for remote
monitoring, remote playback, remote setup. See
configuring the Network connections.
• Reset: The DVR has a Reset switch that will only be used to return all the settings to the
original factory settings. To reset the unit, turn the DVR off first. Turn it on again while poking
the straightened paperclip in the reset hole. Hold the switch until the DVR is initializing.
• Power Connector: Connect adapter cable to the power connector on the rear panel. (DC12V,
3.33A) Input AC power to the adapter. (free voltage from 100V to 240V, 50/60Hz)
14
The RS485 connector can be used to control PTZ cameras.
The DVR can also be controlled remotely by a control
keyboard.
2 alarm output connectors are provided to connect external
alarms such as sirens or lights. Alarm output connectors are
TTL signals.
Chapter 3-2. DVR Configuration
for
Advertisement
Table of Contents
