Reciprocating Saw Model CR 13VC Handling instructions NOTE: Before using this Electric Power Tool, carefully read through these HANDLING INSTRUCTIONS to ensure efficient, safe operation. It is recommended that these INSTRUCTIONS be kept readily available as an important reference when using this power tool.
wrenches are removed from the tool before turning GENERAL OPERATIONAL PRECAUTIONS it on. 17. Avoid unintentional starting. Do not carry a plugged- WARNING! When using electric tools, basic safety in tool with a finger on the switch. Ensure switch is precautions should always be followed to reduce the risk off when plugging in.
SPECIFICATIONS Voltage 240V Power Input 1010 W Capacity Mild Steel Pipe: O.D. 130 mm Vinyl Chloride Pipe: O.D. 130 mm Wood: Depth 300 mm Mild Steel Plate: Thickness 19 mm No-Load Speed 0 – 2800 /min Stroke 29 mm Weight (without cord) 3.3 kg operating immediately, which could cause a serious STANDARD ACCESSORIES...
Page 4
(3) Insert the saw blade all the way into the small slit of 5. Dismounting the blade the plunger tip with the lever pushing. You can mount (1) Turn on and off the switching trigger several times so this blade either in the upward or downward direction. that the lever can jump out of the front cover (Fig.
Page 5
NOTE: Base Continued use of the tool without cleaning and lubricating the area where the saw blade is installed can result in some slack movement of the lever due to accumulated sawdust and chips. Under the circumstances, pull a rubber cap provided on the lever in the direction of an arrow mark as shown in Fig.
Stroke Example of materials Recommended to be cut dial scale Mild steel pipes / cast-iron tubes / 2 – 4 L-shaped angle steel Wood / wood with nails driven in Stainless steel 1 – 3 Aluminum / brass / copper 2 –...
Page 7
(2) When cutting metallic materials, use proper machine oil (turbine oil, etc.). When not using liquid machine oil, apply grease over the workpiece. CAUTION The service life of the saw blade will be drastically shortened if you don’t use machine oil. (3) Use the dial to adjust the speed of the saw blade to suit your working conditions and materials.
CAUTION NOTE Avoid plunge cutting for metallic materials. This can No. 1 – No. 96 HCS blades are sold separately as optional easily damage the blade. accessories. Never pull the switch trigger while the tip of the saw 2. Selection of BI-METAL blades blade tip is pressed against the material.