Page 1
DT7&DR16 2.4 GHz RC System User Manual 2015.02 V2.0...
Page 2
This product and manual are copyrighted by DJI with all rights reserved. No part of this product or manual shall be reproduced in any form without the prior written consent or authorization of DJI.
Page 3
Trainer Port The trainer port outputs the remote controller signal. There are three functions: (1) Connect the remote controller to DJI Lightbridge via the trainer port. Refer to the DJI Lightbridge User Manual for more details. (2) Connect the remote controller to a simulator with PPM input.
Page 4
3. Poke the link button on the receiver with a thin object and hold. Once the LED indicator on the receiver blinks red, release it. 4. When the LED indicator becomes solid green, the link between the DT7 remote controller and the DR16 receiver has been successfully established.
Page 5
Channels Channels Using the RC SYSTEM Assistant The RC SYSTEM Assistant is used to configure the DT7 remote controller, upgrade its firmware, select the control mode and calibrate the sticks. Download, Installation & Connection 1. Download it from DJI website (http://www.dji.com/product/dt7-dr16-rc-system) or scan the QR code below to get the download link.
Need help?
Do you have a question about the DT7 and is the answer not in the manual?
Questions and answers