Chain Case - BOMBARDIER Safari 377 1988 Operator's Manual

Chain case
Drain the chaincase and refill to proper
level, using fresh chaincase oil (PIN 413
8019 00-250 ml (9 oz)). To drain, remove
the chaincase cover.
0
NOTE: Chaincase oil capacity is
about 200 ml (7 oz).
Drive Pulley
Inspection and cleaning must be per-
formed by the dealer at the end of each
season.
Engine and Primer
Lubrication
Engine internal parts must be lubricated
to protect them from possible rust for-
mation during the storage period.
To perform the storage procedures (en-
gine and primer valve) proceed as fol-
lows:
1. Lift the rear of the vehicle and support
it off the ground.
•
WARNING: Ensure the track is
free of all particles which could
be thrown out while it is rotating. Keep
hands, tools, feet and clothing clear of
track. Ensure no one is standing in close
proximity to the vehicle.
2. Start the engine and allow it to run
at idle speed until the engine reaches
its operational temperature.
3. Stop the engine.
4. Disconnect the inlet primer hose from
the primer valve.
A002002009
Inlet (Oblique
hose coupling)
Outlet
hose
(Straight
coupling)
5. Plug inlet primer hose to prevent gas-
oline from draining.
6. Using an appropriate hose, connect
one end of the hose to the inlet of
the primer valve and place the other
end in a Bombardier Snowmobile In-
jection Oil container.
7. Activate the primer in order to fill it
with oil.
8. Restart engine and run at idle.
9. Using the primer valve, inject oil until
the engine dies or until a sufficient
quantity of oil has entered the en-
gine (approximately twenty-five (25)
complete strokes of the primer).
10. The engine stopped, remove the
spark plugs and pour approximately
85 ml (3 imp. oz) of oil into the cyl-
inders.
11. Crank the engine to allow the crank-
shaft to turn two (2) or three (3) revo-
lutions.
12. Reinstall the spark plugs and the inlet
primer hose.
Do not run engine during storage period.
-------------------------39