Headlamp Beam Aiming; Bulb Replacement - BOMBARDIER Safari 377 1988 Operator's Manual

Headlamp Beam Aiming
The angle of the headlamp beam has
been pre-adjusted prior to delivery. Should
a readjustment is necessary, place the
vehicle on a flat surface 381 em (12' 6")
from a wall or screen.
With the suspension correctly adjusted,
the rider seated on the vehicle and the
high beam ON check that the center of
high intensity zone of high beam is 25
mm (1") below horizontal line of head-
lamp height.
Headlamp center line
C:$! t JJ
!oo
£1
A002004010
~
381 em (12' 6")
25
mm 11")
below headlamp center
Headlamp horizontal
center line
Light beam center
25
mm 11")
A002004007
To adjust, remove the four (4) caps, turn
upper or lower adjusting screws to ob-
tain desired beam position.
Bulb Replacement
If the headlamp bulb is burnt, tilt hood,
unplug the connector from the head lamp.
Remove the rubber boot and unfasten
bulb retainer clips. Detach the bulb and
replace.
'W'
CAUTION: Never touch glass por-
T
tion of an halogen bulb with bare
fingers, it shortens it's operating life.
If by mistake glass is touched clean it
with a glass cleaner that will not leave
a film on the bulb.
A002004009
If taillight bulb is burnt, expose the bulb
by removing the red plastic lens. To re-
move, unfasten the two (2) screws.
•
WARNING: Always check light
operation after bulb replacement.
-------------------------37