Yanmar Lx410 Operator's Manual page 55

9. Check the Lights on the Instrument
Panel
After the key is turned to the ON position:
● The parking brake indicator light turns ON if the
parking brake is engaged.
● The engine oil pressure warning light turns ON.
● The alternator/battery charging light turns ON.
(E)
(D)
(C)
42 P1080979
(A) Neutral indicator light
(B) Parking brake indicator light
(C) Glow plug indicator light for Lx410/Lx450
model
Air heater indicator light for Lx490 model
(D) Alternator/Battery charging light
(E) Engine oil pressure warning light
NOTE
● The engine oil pressure light turns OFF within 5
seconds after the engine has started.
● The alternator/battery charging light turns OFF
within 10 seconds after the engine is started.
● If the neutral indicator light fail to turn on the
forward/N/reverse lever is engaged.
IMPORTANT
● If the engine oil pressure light fails to turn OFF
within 5 seconds after the engine is started:
• shut off the engine and check for the cause.
● If no specific cause is detected, but a problem
still persists:
• contact YOUR LOCAL YANMAR TRACTOR
DEALER for technical assistance
1. Turn the starter key switch to the ON position.
2. Energize the glow plug for 15 seconds to allow
easy starting of the engine.
3. The glow plug indicator light is turned OFF after
15 seconds.
7. OPERATE THE ENGINE
(A) (B)
4. Depress the clutch pedal fully.
v30_w_c5-P34_n1_P1080277
(A) Clutch pedal
5. Turn and hold the key to the START position.
6. After the engine has successfully started, release
the key.
NOTE
● If the key is released before the engine started:
• wait until both the starter and engine stop
rotating before trying to start the tractor again
450070118 Starter
(A) OFF position
(B) ON position
(C) START position
IMPORTANT
● Continuous activation of the starter for more than
20 seconds can damage the starter.
● If the engine fails to start within 20 seconds,
discontinue activating the starter.
● Wait for 2 minutes before trying to restart the
engine.
7. Release the clutch pedal slowly.
8. After the engine has started, warm up the engine
for 5 minutes at 1200 to 1500 Revolutions Per
Minute (rpm) without any load.
7-6
Lx410/450/490 Operator's Manual
(A)
(A) (B)
(C)