Inspect The Transmission Hydraulic Oil Level - Yanmar Lx410 Operator's Manual

(a)
(b)
50 dipstick
(A) Dipstick
(a) Upper mark
(b) Lower mark
NOTE
If the engine oil level is low:
● Remove the engine oil filler cap.
● Add the specified engine oil until the engine oil
level is in the operating range on the dipstick.
NOTICE
● Avoid overfilling the engine with engine oil.
(B)
450140204
(A) Engine oil filler cap
(B) Dipstick
12.If the engine oil exceeds the upper mark level on
the dipstick:
• Drain the engine oil to a proper level.
13.Insert the dipstick to check the engine oil level.
14.Lower the hood.
14. PERIODIC SERVICE
(A)
(A)
14-4
■ Inspect the Transmission Hydraulic Oil
Level
1. Park the tractor safely and securely.
• For details, see "7. Safe Practices for Parking the
Tractor" on page 1-7.
2. Shut off the engine.
3. Chock all the tires safely and securely.
4. Allow the engine to cool down for several
minutes.
IMPORTANT
● Before removing transmission hydraulic oil filler
cap and dipstick, carefully clean the area around
the transmission hydraulic oil filler cap and
dipstick.
● The preceding action prevents dirt and other
contaminants from entering the transmission.
● Avoid overfilling the transmission with
transmission hydraulic oil.
(A)
45014020205_P14-4_tofc_d
(a)
(b)
P1110374
(A) Transmission hydraulic oil filler cap
(B) Dipstick
(a) Upper mark
(b) Lower mark
5. Remove the transmission hydraulic oil dipstick.
6. Use a clean rag to wipe the transmission
hydraulic oil from dipstick.
7. Fully insert and then pull out the dipstick again.
8. Read the transmission hydraulic oil level on the
dipstick.
• The transmission hydraulic oil level should be
between the upper mark and lower mark of the
dipstick.
Lx410/450/490 Operator's Manual
(B)
(B)