Instrument Panel - Yanmar Lx410 Operator's Manual

3. Instrument Panel

(11)
(10)
(9)
42 P1080979
(1) Forward/N/reverse lever N (neutral) indicator
light
Indicates the forward/N/reverse lever is in the N
(neutral) position.
(2) Turn signal/hazard indicator lights
Indicates when the corresponding turn signal/hazard
lights is illuminated/flashing.
NOTE
● The hazard lights remain flashing even when the
starter key switch is in the OFF position.
● Allowing the turn signal/hazard lights to flash for
an extended period can lead to loss of battery
voltage.
(3) Power Take Off (PTO) indicator light
Power Take Off (PTO) indicator light illuminates
when Power Take Off (PTO) switch is in the ON
position.
(4) Parking brake indicator light
Indicate parking brake is engaged.
NOTE
● In some cases, even when the parking brake lock
lever appears to be in the "LOCKED" position, the
parking brake itself may not be actually securely
locked.
5. NAMES AND FUNCTIONS OF COMPONENTS
(2)
(8) (7)
(1) (2)
(6) (5)
(5) Coolant temperature gauge
Indicate the current coolant temperature.
If the needle points to within the red zone, the engine
is too hot.
IMPORTANT
● Decrease the load on the tractor:
• when the pointer on the coolant temperature
gauge reaches the abnormally high
temperature
• when the pointer on the coolant temperature
gauge jumps up or rapidly increases
● To lower the coolant temperature:
• idle the engine until the reading on the gauge
falls to the green zone
• shut off the engine
• allow the engine to cool down
● After the preceding actions, check the following:
• the coolant level in the radiator and in the
reserve tank are adequate
• the radiator and radiator screen are free from
dust deposits
• the alternator/fan belt tension is correct
For details, see "Chapter 14. PERIODIC SERVICE"
on page 14-1.
● If the pointer on the coolant temperature gauge
enters the red zone or the reading rapidly
increases again:
• shut down the engine
• immediately contact YOUR LOCAL YANMAR
TRACTOR DEALER for technical assistance
5-13
Lx410/450/490 Operator's Manual
(3)
(4)