Table of Contents
Advertisement
STAB, FIN & RUDDER
Cut and remove the covering material about 3mm inside the stab
and fin. Be careful only cut the covering or it will hurt the structure of
the stab and fin. Using Rubbing Alcohol to remove the mark.
With the main wing installed, make sure the stab and fin are paral-
lel and perpendicular to the main wing. If not, adjust them then glue
them in place when satisfied.
Install the Tail Gear by drilling 3mm(1/8") holes for the tail gear
retaining pins.
Insert the tail gear in place then secure with 3x12mm and 3x15mm
Wood Screws.
Trial fit the Rudder. Cut the slot and drill a hole for tail gear torque
rod on the rudder at the proper position as shown.
Install the Rudder in place, glue the CA hinges and tail gear torque
rod.
9
Advertisement
Table of Contents
