Table of Contents
Advertisement
Be careful install the main wing on the fuselage and not to touch
the sharp end of wing bolts. Push it to mark the points on the wing
when wing is aligned.You can see the two points at the trailing edge
of wing panel.
75˚
Drill 6mm(1/4") holes at the points. Note: The bit should be 75-
degree angled to the wing surface when you are drilling the hole.
STAB, FIN & RUDDER
III. Install the Stab, Fin & Rudder
Glue the CA hinges on the stab as what you did for aileron.
Cut away the covering at the rear fuselage where stab located. Also
remove the covering from the 10mm (3/8") wide flat strip at the top
rear end of the fuselage. Carefully cut 1/2" deep on either side of the
exposed area and remove the block inside (this block should be loose
from the factory but is only there for strength during sanding and cov-
ering.)
Place the stab and vertical fin in place then mark them against the
edge of fuselage.
8
Advertisement
Table of Contents
