Table of Contents
Advertisement
IV. Elevator / Rudder Servo Linkage
and Control Horns
Cut away the covering of pushrod exit holes.
Install the elevator pushrod, you might wisely to bend the pushrod
to Y style and two threaded ends go out the exit holes. Install the cle-
vis on the threaded end.
Place the control horn on the bottom side of the elevator and mark
screw holes with a pen or marker. Drill the holes all the way through
the elevator.
STAB, FIN & RUDDER
Secure the control horn using 2x15mm screws provided.
Install the rudder control horn. Similar procedure to elevator con-
trol assembly.
Trim the Pushrod Fairing and glue them at the pushrod exits.
10
Advertisement
Table of Contents
