Kit Simply Bracket Pack Contents - Proteco SIMPLY Installation Manual

Kit Simply Bracket Pack Contents

Kit Simply - Before Installation.....
Tools Needed:
Tape Measure
Power Drill
Adjustable wrench
Hacksaw or Heavy Duty Bolt Cutters
Small (flat head) screwdriver
Small (Pozi Drive) Phillips screwdriver
Wire Strippers
You may also need these items before you begin the installation
(Some of these items can be found on GateMotors website):
Low voltage wire
This will need to be run from the control board to the photocells (transmitter and receiver) and for the key
switch (optional to fit).
1.5mm 3 Core 230v Armoured Cable
This will be used to transport 230v power form the house to the gate control board.
0.75mm SWA Alarm Cable / CAT 5 Cable (low voltage cable)
This will be used to transport power and switching signals from the photocell units to the control board.
PVC Conduit
To encase power cables / low voltage cables that are running between the house and the control board and
any cables that are to be laid across your driveway.
Surge Protection
A form of circuit breaker should be fitted between the house and the main gate to protect both the gate
control board and the house main fuse box from any power surges that may be experienced.
Page 9