Panasonic WH-MDC09C3E8 Service Manual page 47

B. IF REMOTE CONTROLLER CABLE IS EXPOSED
1 Install the remote controller lower case to the
wall with the two accessory screws (4).
2 Fasten the screws properly until screw head is
lower than the rib and reach the base of remote
controller lower case to ensure they do not
damage the PCB inside the remote controller (1).
3 The feeding-out direction for the remote
controller cable can be either via top, left or
right side.
4 Use nipper to cut a notch at the upper case.
(Select the intended feeding-out position)
11.4.3.3 Connecting The Remote Controller Cable To Mono Bloc Unit
Be sure to turn off the main power before installing and connecting the
remote controller. Otherwise, it will cause the electrical shock.
1 Remove the cabinet front plate and cabinet top
plate.
2 Connect the remote controller's connector to
PCB 1 - CN-REMOTE2 as shown in below
illustration. (Refer wiring diagram for detail.)
3 Guide the remote controller cable through the
clamper and Bushing 8. (Refer illustration
"How to connect Remote Controller to PCB" for
detail.)
4 Reinstall the cabinet front plate and cabinet top
plate after connection complete.
11.4.4 Disposal Of Mono Bloc Unit Drain Water

If the unit is used in an area where temperature falls below 0°C for 2 or 3 days in succession, it is recommended
not to use a drain elbow, for the drain water freezes and the fan will not rotate.
CAUTION
Install the hose at an angle so that the water smoothly flows out.
5 Route the remote controller cable (2) inside the
lower case in accordance with the intended
feeding-out direction. (Refer to the illustration at
below)
6 Insert firmly the connector of remote controller
cable (2) to connector (CON1) in the upper
case circuit board. (Refer to the illustration at
below)
7 Secure the remote controller upper case to the
lower case with the tabs provided.
How to connect Remote Controller to PCB
47