Panasonic WH-MDC09C3E8 Service Manual page 46

11.4.3.2 Installing The Remote Controller Unit To The Wall
1 Remove the remote controller (1) lower case.
(Insert a fl at-tipped screw driver or similar tool 2 to
3 mm into one of the gaps at the bottom of the
case, and twist to open. Refer to the illustration at
right.)
Be careful not to damage the lower case.
2 Do not remove the protective tape which is affixed
to the upper case circuit board when remove the
remote controller lower case.
3 Secure the lower case to an outlet box or wall.
Refer to (A) or (B) instructions below depending on
your choice of cable installation.
4 Be sure to use only the screws provided.
5 Do not over tighten the screws, as it may result in
damage to the lower case.
A. IF REMOTE CONTROLLER CABLE IS EMBEDDED
1 Embed an outlet box (JIS C 8336) into the wall.
Outlet box may be purchased separately. Medium-
sized square outlet box (obtain locally) Part No.
DS3744 (Panasonic Co., Ltd.) or equivalent.
2 Secure the remote controller lower case to the
outlet box with the two accessory screws (3). Make
sure that the lower case is fl at against the wall at
this time, with no bending.
3 Pass the remote controller cable (2) into the box.
4 Route the remote controller cable (2) inside the
lower case through rear feeding-out direction.
5 Insert firmly the connector of remote controller
cable (2) to connector (CON1) in the upper case
circuit board. [Refer to the illustration at below.]
6 Secure the remote controller upper case to the
lower case with the tabs provided.
When the wall is hollow, please be sure to use the sleeve for remote controller cable to prevent dangers caused by mice biting the cable.
CAUTION
46