Using The Mini Wedge Cleaning Tool - Shark S2902 Owner's Manual

fig. 13
fig. 15

USING THE MINI WEDGE CLEANING TOOL

Cleaning Tip: The Mini Wedge Cleaning Tool was
designed for cleaning a variety of surfaces and is
exceptional on those that are large and flat, both
horizontal and vertical. Broad cleaning sides and super
absorbent microfiber fabrics loosen, lift, and lock in
dirt and grime while sanitising at the same time. The
wedge tip and squared edges reach into tight areas
often missed or difficult to reach with traditional cleaning
methods. The Wedge sides concave to wrap around sink
and faucet fixtures, door knobs, and other small curved
surfaces leaving them clean all around. Multiple sides
provide more surface cleaning area and allow one to
clean with one side and finish with the other. Surface
examples for use are countertops, tabletops, cabinets,
walls, floor spot cleaning, bathroom fixtures and more.
1
Slide the Wedge All-Purpose Pocket over the Mini
Wedge Cleaning Tool frame until it is completely on.
(fig. 13)
2
Close the cinch by pulling on the elastic band and
sliding the locking bean to tighten. (fig. 14)
3
Attach the Mini Wedge Cleaning Tool by snapping
into the handle of the Accessory Hose until it clicks
into place. (fig. 15)
4
Press the power button to start steaming.
5
To remove the Mini Wedge Cleaning Tool, press and
hold down the Accessory release button. Then slide
out the Mini Wedge Cleaning Tool.
CAUTION: Turn the unit off before attaching or
removing the Mini Wedge Cleaning Tool. Always
use the Mini Wedge Cleaning Tool with a pocket
attached.
CAUTION: It is recommended that you allow the
cleaning pockets to cool off before removing them
from the Mini Wedge Cleaning Tool to avoid possible
scalding injury.
fig. 14
www.sharkclean.com 9