Advertisement
USING YOUR SHARK® STEAM POCKET® MOP
ASSEMBLY CONT.
4
4 Place the mop on a stable, level surface.
Turn the water tank cap counterclockwise
to remove. Use the filling flask to add water
to the tank, making sure to not exceed the
max fill line. Replace the cap and turn it
clockwise to tighten.
6
6 Pull and twist the quick release cord holder
to unwrap the power cord completely.
s h a r kc l e a n . c o m
5
5 To adjust the length of the mop, lift the
latch on the tube 90 degrees to the open
position. Holding the handle, extend the
tube to the height that's right for you and
then close the latch to the locked position.
7
7 Plug into an electrical outlet. The power
light will illuminate. It takes approximately
30 seconds for the mop to heat up and the
steam to be ready.
NOTE: Steam is created automatically with
the mopping motion.
USING YOUR SHARK® STEAM POCKET® MOP
CLEANING OPERATION
Pump the handle a few times in a downward
motion. This pumping action will release
steam as you mop and allows you to
customize the amount of steam you use.
Begin mopping with a forward and backward
motion. The natural motion of mopping will
produce steam.
SANITIZING OPERATION
When one side of the pocket gets dirty, just
turn the mop head over and clean with the
other side of the pad.
When the water tank is empty, the Steam
Pocket Mop will stop producing steam. You
can refill the water tank at any time as long
as the mop is unplugged from the outlet.
TO SANITIZE* WITH THE RECTANGLE MOP
HEAD
1 Only sanitize sealed, hard-floor surfaces.
2 Plug in the Steam Mop, then wait 30
seconds for it to heat up.
3 To activate steam, pump the handle a few
times.
4 Start mopping with a forward and
backward motion. After 3 minutes, your
Steam Mop will be ready to sanitize.
5 Mop the area to be sanitized, moving
forward and backward at least 15 times."
* Sanitization studies were conducted
under controlled test conditions using
the rectangle mop head only. Household
conditions and results may vary.
s h a r kc l e a n . c o m
Advertisement
