Filling The Reservoir; Cleaning Modes - Shark VACMOP VM180 Series Owner's Manual

FILLING THE RESERVOIR

OPEN RESERVOIR LID
Lift the reservoir lid and press it up until it clicks into the open locked position. Carefully pour Shark
VACMOP Cleaner into the reservoir, up to the MAX line. When finished, press the lid closed.
NOTE: Before using your unit for the first time, carefully add the entire starter bottle of Shark VACMOP Cleaner into the reservoir.
New units may have residual moisture in tank from quality testing.

CLEANING MODES

VACUUM
For best results, first use the vacuum to remove dry debris, then spray the Shark VACMOP Cleaner to wet mop.
s h a r kc l e a n . c o m
FILL WITH SHARK® VACMOP™ CLEANER
WET MOP
LEAN AGAINST WALL
After wet cleaning, remove the pad from the Shark VACMOP™ base before storing the unit.
To store the unit, stand it upright and lean the back of the non-slip handle against a wall.
To hang the unit from a nail or wall hook (not included) align the opening at the end of the handle over the
hook or nail.
DISASSEMBLY
NOTE: Once the unit is assembled, do not take it apart, unless for repacking or shipping.
2.
1.
DISASSEMBLE VACUUM HANDLE
1. Press in the snap clip with a small tool
(screwdriver, pen, etc.)
2. While pressing down on the top snap clip, pull the
handle out of the pole.
STORAGE
HANG FROM HOOK
3.
DISASSEMBLE VACMOP BODY
3. Next, press in the snap clip on the Shark VACMOP
body with a small tool.
4. While pressing down on the bottom snap clip, pull
the pole out of the Shark VACMOP body.
s h a r kc l e a n . c o m
4.