Table of Contents
Advertisement
Using Your Removable Handheld Steamer with Flat Scrubber
Cleaning Tip: The Flat Scrubber is designed for cleaning a variety of surfaces and is exceptional on those that are
large and flat including counter tops, table tops, walls mirrors, windows, stairs, shelves and other similar surfaces.
Super absorbent micro-fibre bonnet loosens, lifts, and locks in dirt and grime while sanitizing at the same time.
fig. 26
1
To attach the All-Purpose Scrubber Pad, place the
pad exterior side down on a flat surface (lavender
tab indicates the bottom of the pad) and insert the
top of the Flat Scrubber Tool into the top portion of
the pad and then pull the pad over each side of the
back edge.
2
Press the Flat Scrubber Tool onto the Accessory
Hose until it clicks into place. (fig. 26)
3
Select either DUST, MOP or SCRUB mode by
pressing the ON/STEAM SETTING button and wait
until the selected setting indicator light turns solid
blue. Hold down the steam trigger to start steaming.
(fig. 27)
17
CUSTOMER CARE - NZ: 0800 002 999
fig. 27
4
To remove the Flat Scrubber Tool, press and hold
down the Accessory Hose release button. Then slide
out the Flat Scrubber Tool. (fig. 28)
CAUTION: Do not press the steam trigger while
attaching or removing the Flat Scrubber Tool.
CAUTION: Do not use the Flat Scrubber Tool without
the All-Purpose Scrubber Pad attached.
Using Your Removable Handheld Steamer
with Cylinder Cleaning Tool
Cleaning Tip: The Cylinder Cleaning Tool provides controlled cleaning and reaches into narrow areas and around
curved and contoured surfaces for steam dusting and fine cleaning activities. It is a great cleaning tool for in and
around sinks, bathtubs, refrigerator doors, window sills, door jams and frames, exhaust and intake vents, banisters,
railings, spindles, furniture, seating and more.
fig. 29
fig. 28
fig. 30
1
Slide the Cylinder Cleaning Pocket over the Cylinder
Cleaning Tool frame until it is completely on. (fig. 29)
2
Close the cinch by pulling on the elastic band and
sliding the locking bean to tighten. (fig. 30)
3
Attach the Cylinder Cleaning Tool by snapping into
the handle of the Accessory Hose. (fig. 31)
4
Select either DUST, MOP or SCRUB mode by
pressing the ON/STEAM SETTING button and wait
until the selected setting indicator light turns solid
blue. Hold down the steam trigger to start steaming.
(fig. 32)
fig. 31
fig. 32
5
To remove the Cylinder Cleaning Tool, press and
hold down the Accessory release button. Then slide
out the Cylinder Cleaning Tool.
CAUTION: Do not press steam trigger while
attaching or removing the Cylinder Cleaning Tool.
Always use the Cylinder Cleaning Tool with Bonnet
attached.
CUSTOMER CARE - AU: 1800 890 840
18
Advertisement
Table of Contents
