Other Features; Error Codes And Protection Code; Setting The Timer - Kenmore 405.54530 Use & Care Manual

O Display
Shows the set % humidity level from 35°/0 to 85°/0 or auto start/stop time
(0~24) while setting, then shows the actual (+5°/0 accuracy) room %
humidity level in a range of 30°/0 RH (Relative Humidity) to 90°/0 RH (Relative
Humidity).
Error Codes and Protection Code:
AS- Humidity sensor error--Unplug the unit and plug it back in. If error repeats,
arrange for service.
ES- Temperature sensor error-- Unplug the unit and plug it back in. If error
repeats, arrange for service.
P2- Bucket is full or bucket is not in right position-- Empty the bucket and
replace it in the right position.
EC- Unit Malfunction--Check to verify that the surrounding temperature is within
the range of 41°F (5 °C) to 95 °F (35 °C). If the temperature is not within range,
take action to correct the surrounding temperature. If the EC code persists,
there is a malfunction that requires you to call for service. Some causes of this
EC error code could be a refrigerant leak, an overload or failure of the compressor,
or blockage in the sealed system.
OTHER FEATURES
Bucket Full Light - Lights up when the bucket is full and ready to be emptied, or
when the bucket is removed or not replaced in the proper position.
Auto Shut Off - The dehumidifier shuts off: after 30 seconds when the bucket is
full, or when the bucket is removed or not replaced in the proper position. When
the set humidity level is reached, the compressor will shut off, and the fan will
continue to run for another 3 minutes, and then shut off.
Auto Defrost - When frost builds up on the evaporator coils, the compressor
will cycle off: and the fan will continue to run until the frost disappears.
3 Minute Compressor Delay- Any time the compressor stops running for any
reason, such as when the humidity set point has been reached, it will not restart
again for a minimum of 3 minutes. This is a safety design to prolong the life of
the compressor. If the fan has also stopped, it will not restart again for 3
minutes or until the compressor starts.
Check Filter Feature -The unit tracks the amount of time that the fan runs. The
Filter light will start to flash once a second after 250 hours of operation. After
cleaning the air filter, press the Filter button for one second to reset this timer.
Auto-Restart - If there is a power failure, the unit will return to the same operating
condition when the power is restored.
Setting the Timer
• With the unit on, press the Timer button, and the Off: light indicates that the Auto
Stop function may be programmed. Within 5 seconds press the UP or DOWN
buttons to select a period of time after which operation will stop. Press the Timer
button twice and the On light indicates that the Auto Start function may be
programmed. Within 5 seconds press the UP or DOWN buttons to select a period
of time after which operation will resume.