BAR AND CHAIN INSTALLATION
STEP 1
Loosen side cover nuts and remove side
cover.
STEP 2
Place bar onto studs and chain adjustment
pin.
STEP 3
Turn chain-tensioning screw CCW until the
bar comes into contact with the drive
814 OPERATOR'S MANUAL
SET-UP
STEP 4
Mount the chain on the bar starting at the
drive sprocket & continue over the bar nose.
Install the chain correctly. The bumper must
STEP 5
Make sure all the drive links are inside the bar
groove then pre-tension the chain.
7
always lead the segment into
the cut as shown here.