TITLE
SET-UP
GUIDE BAR AND DIAMOND CHAIN INSTALLATION
STEP 1
Loosen side cover nuts and remove
side cover.
STEP 2
Place bar onto studs and chain
adjustment pin.
STEP
Turn chain-tensioning screw CCW
until the bar comes into contact with
the drive sprocket.
8
STEP
Mount the chain on the bar starting
at the drive sprocket & continue over
the bar nose.
Install the chain correctly. The
bumper must always lead the
segment into the cut as shown here.
STEP 5
Make sure all of the drive links are
inside the bar groove then pre-
tension the chain.
© 2007 ICS, Blount Inc.
880 OPERATOR'S MANUAL
F/N 525665 Oct 07