Table of Contents
Advertisement
PETROL
LINE TRIMMER
25.4CC 2 Stroke
INSTRUCTION MANUAL
SPECIFICATIONS
Engine:
25.4cc 2-stroke
Power Output:
0.75kW (1HP)
Fuel & Oil Mix:
40:1
Fuel Tank Capacity:
0.45L
Max. No Load Speed:
7500/min
Cutting Width:
380mm
Weight:
5.7kg
ozito.com.au
1
WHAT'S IN THE BOX
Line Trimmer
Lower Shaft
Safety Guard
Handle Assembly
Shaft Screw
Line and Spool
Spool Key
Spanner
Spark Plug
Wrench
Fuel Mixture
Shoulder
Bottle
Strap
PLT-380
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Ozito PLT-380
Summary of Contents for Ozito PLT-380
-
Page 1: Line Trimmer
25.4cc 2-stroke Power Output: 0.75kW (1HP) Fuel & Oil Mix: 40:1 Line and Spool Spool Key Fuel Tank Capacity: 0.45L Max. No Load Speed: 7500/min Cutting Width: 380mm Spanner Spark Plug Weight: 5.7kg Wrench ozito.com.au Fuel Mixture Shoulder Bottle Strap PLT-380... -
Page 2: Know Your Product
KNOW YOUR PRODUCT ASSEMBLY PETROL LINE TRIMMER 1. ASSEMBLING THE TRIMMER 1 Strap fastening eyelet 2 Recoil starter 3 Spark plug boot WARNING! DO NOT START THE ENGINE UNTIL 4 Choke lever THE LINE TRIMMER IS FULLY ASSEMBLED. 5 Air filter housing cover 6 Fuel tank Assembly of the long handle 7 Throttle lock-off... -
Page 3: Shoulder Strap
2. FORWARD HANDLE AND SPOOL 3. SHOULDER STRAP Fitting the shoulder strap IMPORTANT: THE SAFETY GUARD MUST BE FITTED BEFORE YOU WORK WITH THE CUTTING LINE. The shoulder strap is intended Fitting the forward handle to help you work safely and ergonomically with the petrol line 1. -
Page 4: Setup & Preparation
OPERATION SETUP & PREPARATION 4. FUEL & OIL 5. STARTING & STOPPING Pre-startup checks WARNING! BE SURE TO STOP THE ENGINE BEFORE 1. E nsure that the safety guard, shaft and forward handle are fitted and REFUELLING. DO NOT SMOKE WHILE REFUELLING. are secure. MOVE AT LEAST 3M AWAY FROM THE FUELLING POINT BEFORE STARTING THE MOTOR. -
Page 5: Cutting Methods
NOTE: Do not hit the spool on concrete or hard surfaces as this may result in damage to the spool or cutting head. If the line does not feed check that the line is not jammed. PLT-380... -
Page 6: Maintenance
MAINTENANCE 7. LINE REPLACEMENT 8. GENERAL MAINTENANCE IMPORTANT: REMOVE ALL GRASS AND WARNING! BEFORE CLEANING YOUR LINE WEED REMAINS AT REGULAR INTERVALS TO TRIMMER OR CARRYING OUT ANY MAINTENANCE PROCEDURE, MAKE SURE THAT THE ENGINE IS OFF PREVENT THE SHAFT TUBE OVERHEATING. GRASS AND IS COOL. -
Page 7: Description Of Symbols
For further information, or any parts not listed here, visit does not Dirty or clogged air filter. Clean the air filter. develop its www.ozito.com.au or contact Ozito customer service full output. Incorrect carburettor setting. Contact an authorized Australia 1800 069 486 customer service outlet. New Zealand 0508 069 486... -
Page 8: Safety Instructions
SAFETY INSTRUCTIONS Read the whole manual carefully and make sure you know how to switch the tool off may result in serious personal injury. in an emergency, before operating the tool. b) Use safety equipment. Always wear eye protection. Safety equipment such as a dust mask, non-skid safety shoes, hard hat, or hearing protection used for Save these instructions and other documents supplied with this tool for future appropriate conditions will reduce personal injuries. -
Page 9: Warranty
• Failure to perform maintenance as set out within the instruction manual. • If the tool is disassembled or tampered with in any way. OZITO Australia/New Zealand (Head Office) 1-23 Letcon Drive, Bangholme, Victoria, Australia 3175. 0614...
Need help?
Do you have a question about the PLT-380 and is the answer not in the manual?
Questions and answers
how to fix starter cord that has broken