Monte Carlo Fan Company 5RDR Series Owner's Manual page 4

19
Install arch mount by using clips in
plastic bag. Place clip through tab
and fasten securely.
22
Push the yoke cover down into
place.
25
Install decorative cap.
28
Hang assembled fan from the mounting brack-
et. Make sure the fan is hanging straight.
Rotate fan until the tab on the Mounting bracket
engages the slot on the Downrod Ball. This
must be done to prevent the fan body from
rotating when the blades are in motion.
20
Tighen all 6 screws for arch arms
securely.
23
Plug in electrical connections there
are 2 double plugs from arch assem-
bly one for the fan and one for the
up and down lights.
26
Thread leadwires and safety cable
through the canopy. Place canopy
over the downrod.
29
Rotate slide on mounting bracket till it stops so
the screw holes will align for 2 canopy screws
in hardware pack. Tighten the 2 screws secure-
ly. These will lock slide in place till ready to
mount canopy. (step 34)
21
Tighen the 3 screws holding the arch
arms securely.
24
Install 6 x 15 watt candelabra tor-
pedo shape bulbs.
27
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
Set dip switches on the Remote T ransmitter and
Remote Receiver to the same settings. This must be
done so the units will communcate properly . If you
have other fans you can set to control from one
transmitter by setting both receivers the same as the
transmitter . If you have more than one fan with
remote. You can set the dip switches to different
positiosns to have seperate control.
30
Safety cable installation
Safety Cable
Lag Screw
safety
cable
washer
lock
3" lag
washer
screw
Fan and light kit combinations over 35 lbs,
in both flush and downrod mode the safety
cable must be installed into the house struc-
ture beams using the 3" lag screws,washers,
and lock washers. provided. Make sure that
when the safety cable is fully extended the
lead wires are longer than the cable and no
stress is placed on the lead wires.