Monte Carlo Fan Company 5RDR Series Owner's Manual page 3

7
Lift mounting neck to mounting Plate and align
screws.
10
Install 3 screws to hold glass to fan
housing. Do not overtighten as this
could crack the glass.
13
Place downrod into the arch yoke
and align the slot in arch yoke and
the hole in the downrod.
16
Place arms over the fan housing.
Make sure the arms with electrical
connection plugs are next to the
plugs on the fan housing.
8
Secure mounting neck to the mounting plate
with 6 screws to become a complete mounting
bracket.
11
Remove pin from downrod and save
for later step 14. Push the yoke
cover onto downrod. Thread lead
wires and safety cable through the
downrod.
14
Raise lead wire, safety cable, and
downrod up and align with slot for
pin in bottom of arch yoke. Push pin
into hole in downrod. After putting
in pin don't twist downrod. Make
sure pin is fully engaged in slot.
17
Close up for showing tab and screw
holes of fan body to place arch arms
over for arch installation.
9
Lower upper glass disk onto fan housing and
align 3 holes in glass with 3 holes in fan hous-
ing.
12
Pull lead wires and safety cable out
from the yoke about 3".
15
Tighten set screws to hold downrod
securely in the arch yoke.
18
Align holes in arch arm and slot for
tab with holes and tab on fan body.
Start all screws in the arch arm
brackets.