Scanning Sequence Examples; Errors While Scanning; Imaging Preferences Parameter Defaults - Symbol DS4308 Product Reference Manual

5 - 2 DS4308/DS4308P Digital Scanner Product Reference Guide

Scanning Sequence Examples

In most cases scanning one bar code sets the parameter value. For example, to disable image capture
illumination, scan the Disable Image Capture Illumination bar code under
page 5-5. The digital scanner issues a fast warble beep and the LED turns green, signifying a successful
parameter entry.
Other parameters require scanning several bar codes. See these parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

Imaging Preferences Parameter Defaults

Table 5-1 lists the defaults for imaging preferences parameters. To change the default values, scan the
appropriate bar codes in this guide. These new values replace the standard default values in memory. To recall
the default parameter values, scan
NOTE See
miscellaneous default parameters.
Imaging Preferences Parameter Defaults
Table 5-1
Parameter
Imaging Preferences
Operational Modes
Image Capture Illumination
Image Capture Autoexposure
Fixed Exposure
Fixed Gain
Gain / Exposure Priority for Snapshot
Mode
Snapshot Mode Timeout
Snapshot Aiming Pattern
Silence Operational Mode Changes
Image Cropping
Crop to Pixel Addresses
*Restore Defaults on page
Appendix A, Standard Default Parameters
Parameter
Number
N/A
361
360
567
568
562
323
300
1293
301
315
316
317
318
Image Capture Illumination on
4-5.
for all user preferences, hosts, symbologies, and
SSI Number Default
N/A N/A
F0h 69h Enable
F0h 68h Enable
F4h F1h 37h 100
F1h 38h 50
F1h 32h Autodetect
F0h 43h 0 (30 seconds)
F0h 2Ch Enable
F8h 05h 0Dh Disable (do not silence)
F0h 2Dh Disable
F4h F0h 3Bh 0 top
F4h F0h 3Ch 0 left
F4h F0h 3Dh 799 bottom
F4h F0h 3Eh 1279 right
Page
Number
5-4
5-5
5-5
5-6
5-6
5-7
5-8
5-9
5-9
5-10
5-11