Engine Poor Performance; Rear Wheel Spins At Idle; Starting Difficulties - PIAGGIO Carnaby 125 Service Station Manual

Table of Contents

Advertisement

Carnaby 125 - 200
Engine
Poor performance
Possible Cause
The carburettor is dirty; fuel pump or vacuum valve damaged Remove, wash with solvent and dry with compressed air or re-
Excess of encrustations in the combustion chamber
Incorrect timing or worn timing system elements
Muffler obstructed
Air filter blocked or dirty.
Automatic starter failure
Oil level exceeds maximum
Lack of compression: parts, cylinder and valves worn
Transmission belt worn
Inefficient automatic transmission
Clutch slipping
Overheated valves
Wrong valve adjustment
Valve seat distorted
Defective floating valve

Rear wheel spins at idle

REAR WHEEL ROTATES WITH ENGINE AT IDLE
Possible Cause
Idling rpm too high
Clutch fault

Starting difficulties

Possible Cause
Altered fuel characteristics
Rpm too low at start-up or engine and start-up system dam-
Incorrect valve sealing or valve adjustment
- Engine flooded.
Automatic starter failure
Air filter blocked or dirty.
Faulty spark plug or incorrect ignition advance
POOR PERFORMANCE
DIFFICULT STARTING
aged
Operation
place
Descale the cylinder, the piston, the head and the valves
Time the system again or replace the worn parts
Replace
Remove the sponge, wash with water and car shampoo, then
soak it in a mixture of 50% petrol and 50% specific oil. Press
with your hand without squeezing, allow it to drip dry and refit.
Check: mechanical movement, electric connection and fuel
supply, replace if required.
Check for causes and fill to reach the correct level
Replace the worn parts
Replace
Check the rollers, the pulley movement and make sure the
drive belt is in good conditions; replace the damaged parts and
lubricate the moveable driven pulley with specific grease.
Check the clutch system and/or the bell and replace if neces-
sary
Remove the head and the valves, grind or replace the valves
Adjust the valve clearance properly
Replace the head assembly
Check the proper sliding of the float and the functioning of the
valve
Operation
Adjust the engine idle speed.
Check the springs / clutch masses
Operation
Drain off the fuel no longer up to standard; then, refill
Check the starter motor, the system and the torque limiter
Inspect the head and/or restore the correct clearance
Try starting-up with the throttle fully open. If the engine fails to
start, remove the spark plug, dry it and before refitting, make
the motor turn so as to expel the fuel excess taking care to
connect the cap to the spark plug, and this in turn to the ground.
If the fuel tank is empty, refuel and start up.
Check: mechanical movement, electric connection and fuel
supply, replace if required.
Remove the sponge, wash with water and car shampoo, then
soak it in a mixture of 50% petrol and 50% specific oil. Press
with your hand without squeezing, allow it to drip dry and refit.
Replace the spark plug or check the ignition circuit components
Troubleshooting
TROUBL - 57

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Carnaby 200

Table of Contents