Lubrication Circuit - PIAGGIO Carnaby 125 Service Station Manual

Carnaby 125 - 200
For the 200 models reposition the shim washers
as in the original fitting.
- Fit the 11 screws and tighten them to the pre-
scribed torque.
- Lubricate the flywheel oil seal.
- Using the appropriate tool, assemble the oil seal.
- Fit a new O-ring on the pre-filter and lubricate it.
- Insert the filter on the engine with the relative cap.
Tighten to the specified torque.
N.B.
FAILURE TO USE THE SPECIFIC TOOL CAN RESULT IN
AN INCORRECT DEPTH POSITION AND AS A CONSE-
QUENCE IN INADEQUATE OIL SEALING.
Specific tooling
020425Y Punch for flywheel-side oil seal
Locking torques (N*m)
Internal engine crankcase bulkhead (transmis-
sion-side half shaft) screws
crankcase fitting
27 ÷ 33
pling screws Engine oil drainage plug/
11 ÷ 13
mesh filter
24 ÷ 30
Lubrication
Conceptual diagrams

LUBRICATION CIRCUIT

Oil filter on
4 ÷ 6
Engine-crankcase cou-
Engine
ENG - 161